

Initial release using Sigma SDK 6.81.00 which adds security S2 and SmartStart. v2.1: Upgrade to SmartStart – Z-Wave Certification rev.| Various other small changes were required to pass certification but would not impact typical users. This is a change in the certification and the sensor MUST always send a sensor reading. | The parameter value of 0 is no longer valid for the sensor readings. ZWave Library 6.81.00 – ONLY FOR UNITS WITH SCREW TAB!Īdded the Supervision Command Class to the non-secure NIF. | To get the settings for the changes, please update to the latest Beta of the Z-Wave plugin 3.0.1.234 or later. Note that a central scene command for single taps IS still sent. When disabled, the load will respond instantly to paddle presses. | Ability to disable the multi-tap feature on both WS and WD. This allows other WX200 devices to used as companion switches. Any device added to group 2 will be controlled. v5.12: Added a parameter to allow for lower dimming on the WD200.

This ensures that both dimmers LEDS stay in sync. v5.13: When using group 2 association the controlling dimmer will send a BASIC SET to the associated dimmer after it reaches the desired dim level.If you install it on any other device, it may render that device inoperable. If it fails, do a connectivity check, then remove.Ĭareful: Be sure to install this dimmer firmware on the HS-WD200+ dimmer. After adding the switch back in, click on the old device then Z-Wave tab, then “Remove Bad Node” to remove the node from the Z-Wave interface. You will need to add the switch back into your network. This was an unfortunate consequence of adding the group 2 association feature. Note: When updating to this firmware the node ID of the switch will be lost.

